Server Auth-Port - Allied Telesis x310-26FT Command Reference Manual

L RADIUS S C
OCAL ERVER OMMANDS
-
SERVER AUTH PORT

server auth-port

Overview Use this command to change the UDP port number for local RADIUS server
authentication.
Use the no variant of this command to reset the RADIUS server authentication port
back to the default.
Syntax server auth-port <1-65535>
no server auth-port
Default The default local RADIUS server UDP authentication port number is 1812.
Mode RADIUS Server Configuration
Examples The following commands set the RADIUS server authentication port to 10000.
awplus#
awplus(config)#
awplus(config-radsrv)#
The following commands reset the RADIUS server authentication port back to the
default UDP port of 1812.
awplus#
awplus(config)#
awplus(config-radsrv)#
Related server enable
Commands
show radius local-server statistics
C613-50103-01 REV A
Parameter Description
<1-65535>
UDP port number.
configure terminal
radius-server local
configure terminal
radius-server local
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
server auth-port 10000
no server auth-port
1797