Ipv6 Pim Unicast-Bsm - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM UNICAST BSM

ipv6 pim unicast-bsm

Overview Use this command to enable support for the sending and receiving of unicast Boot
Strap Messages (BSM) on a VLAN interface.
Use the no variant of this command to disable the sending and receiving of unicast
BSM on a VLAN interface.
Syntax ipv6 pim unicast-bsm
no ipv6 pim unicast-bsm
Mode Interface Configuration for a VLAN interface.
Default Unicast BSM is disabled by default on an interface.
Usage This command provides backward compatibility with older versions of the Boot
Strap Router (BSR) specification, which directs unicast BSM to refresh the state of
new or restarting neighbors. The current BSR specification defines a No Forward
BSM to achieve the same result.
Examples awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim unicast-bsm
configure terminal
interface vlan2
no ipv6 pim unicast-bsm
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1300