Ipv6 Pim Spt-Threshold Group-List - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM SPT THRESHOLD GROUP

ipv6 pim spt-threshold group-list

Overview Use this command to turn on/off the ability for the last-hop PIM-SMv6 router to
switch to SPT (shortest-path tree) for multicast group addresses as specified by the
given software IPv6 access-list.
Use the no variant of this command to turn off switching to the SPT.
NOTE
not at all; it is not rate-based.
ipv6 pim spt-threshold group-list <IPv6-access-list>
Syntax
no ipv6 pim spt-threshold group-list <IPv6-access-list>
Mode Global Configuration
Examples To enable the last-hop PIM-SMv6 router to switch to SPT for groups specified by
the ACL named G1, use the following commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
2001:db8::/128
To stop the last-hop PIM-SMv6 router from being able to switch to SPT for groups
specified by the ACL named G1, use the following commands:
awplus#
awplus(config)#
Related ipv6 pim spt-threshold
Commands
C613-50103-01 REV A
-
LIST
: The switching to SPT happens either at the receiving of the first data packet, or
Parameter
<IPv6-access-list>
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim spt-threshold group-list G1
ipv6 access-list standard G1 permit
configure terminal
no ipv6 pim spt-threshold group-list G1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify a Standard or an Extended software IPv6 access-
list name.
See the IPv6 Software Access Control List (ACL)
Commands chapter for supported IPv6 ACLs.
1298