Wrr-Queue Weight Queues - Allied Telesis x310-26FT Command Reference Manual

Q S C
O OMMANDS
-
WRR QUEUE WEIGHT QUEUES

wrr-queue weight queues

Overview This command configures weighted round-robin based scheduling on the
specified egress queues on switch port interfaces only. The weights are specified
as ratios relative to each other.
wrr-queue weight <1-15> queues [0][1][2][3][4][5][6][7]
Syntax
Mode Interface Configuration for switch port interfaces only (not for static aggregated
interfaces).
Usage You cannot apply weighted round-robin based scheduling to static aggregated
interfaces (for example, awplus(config)#interface sa2). Attempting to
apply weighted round-robin based scheduling on aggregated interfaces will
display the console error shown below:
awplus#
awplus(config)#
awplus(config-if)#
% Invalid input detected at ^ marker
Example To apply a WRR weight of 6 to queues 0 and 1 on port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related priority-queue
Commands
show mls qos interface
C613-50103-01 REV A
Parameter Description
<1-15>
Weight (the higher the number the greater will be the queue
servicing).
[0][2]...[7]
Selects one or more queues numbered 0 to 7.
configure terminal
interface sa2
configure terminal
interface port1.0.1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
wrr-queue weight
wrr-queue weight 6 queues 0 1
1543