Distribute-List (Ipv6 Ripng) - Allied Telesis x310-26FT Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
- (IP 6 RIP )
DISTRIBUTE LIST V NG

distribute-list (IPv6 RIPng)

Overview Use this command to filter incoming or outgoing route updates using the
access-list or the prefix-list.
Use the no variant of this command to disable this feature.
Syntax distribute-list [<access-list>|prefix <prefix-list-name>]
[in|out] [<interface>]
no distribute-list [<access-list>|prefix <prefix-list-name>]
[in|out] [<interface>]
no distribute-list [prefix <prefix-list-name>] [in|out]
[<interface>]
Default Disabled
Mode Router Configuration
Usage Filter out incoming or outgoing route updates using the access-list or the
prefix-list. If you do not specify the name of the interface, the filter is applied to all
the interfaces.
Example To filter incoming or outgoing route updates, use the following commands:
awplus#
awplus(config)#
awplus(config-router)#
Related ipv6 access-list extended (named)
Commands
ipv6 nd prefix
C613-50103-01 REV A
Parameter
<access-list>
<prefix-list-name>
<interface>
in
out
configure terminal
router ipv6 rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specifies the IPv6 access-list number or name to use.
Filter prefixes in routing updates.
Specify the name of the IPv6 prefix-list to use.
The interface for which distribute-list applies. For instance:
vlan2.
Filter incoming routing updates.
Filter outgoing routing updates.
distribute-list prefix myfilter in vlan2
841