Ip Pim Bsr-Border - Allied Telesis x310-26FT Command Reference Manual

PIM-SM C
OMMANDS
-
IP PIM BSR BORDER

ip pim bsr-border

Overview Use the ip pim bsr-border command to prevent Bootstrap Router (BSR) messages
from being sent or received through a VLAN interface. The BSR border is the border
of the PIM domain.
Use the no variant of this command to disable the configuration set with ip pim
bsr-border.
ip pim bsr-border
Syntax
no ip pim bsr-border
Mode Interface Configuration for a VLAN interface.
Usage When this command is configured on a VLAN interface, no PIM version 2 BSR
messages will be sent or received through the interface. Configure an interface
bordering another PIM domain with this command to avoid BSR messages from
being exchanged between the two PIM domains.
BSR messages should not be exchanged between different domains, because
devices in one domain may elect Rendezvous Points (RPs) in the other domain,
resulting in loss of isolation between the two PIM domains that would stop the PIM
protocol from working as intended.
Examples The following example configures the VLAN interface vlan2 to be the PIM domain
border:
awplus#
awplus(config)#
awplus(config-if)#
The following example removes the VLAN interface vlan2 from the PIM domain
border:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
interface vlan2
ip pim bsr-border
configure terminal
interface vlan2
no ip pim bsr-border
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1217