Cisco-Metric-Behavior (Rip) - Allied Telesis x310-26FT Command Reference Manual

RIP C
OMMANDS
- - (RIP)
CISCO METRIC BEHAVIOR

cisco-metric-behavior (RIP)

Overview Use this command to enable or disable the RIP routing metric update to conform
to Cisco's implementation. This command is provided to allow inter-operation
with older Cisco devices that do not conform to the RFC standard for RIP route
metrics.
Use the no variant of this command to disable this feature.
cisco-metric-behavior {enable|disable}
Syntax
no cisco-metric-behavior
Default By default, the Cisco metric-behavior is disabled.
Mode Router Configuration
Examples To enable the routing metric update to behave as per the Cisco implementation,
enter the commands:
awplus#
awplus(config)#
awplus(config-router)#
To disable the routing metric update to behave as per the default setting, enter the
commands:
awplus#
awplus(config)#
awplus(config-router)#
Validation show running-config
Commands
C613-50103-01 REV A
Parameter Description
enable
Enables updating the metric consistent with Cisco.
disable
Disables updating the metric consistent with Cisco.
configure terminal
router rip
configure terminal
router rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
cisco-metric-behavior enable
no cisco-metric-behavior
787