Show Interfaces Switchport - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays detailed information for unit/port "1/g1."
console#show dvlan-tunnel interface 1/g1
Interface Mode
--------- ------- --------------
1/g1 Enable
The following table describes the significant fields shown in the example.
Field
Mode
Interface
EtherType

show interfaces switchport

Use the show interfaces switchport command in Privileged EXEC mode to
display switchport configuration.
EtherType
vMAN
Description
This field specifies the administrative mode through which
Double VLAN Tunneling can be enabled or disabled. The default
value for this field is
Interface Number.
This field represents a 2-byte hex EtherType to be used as the first
16 bits of the DVLAN tunnel. The three different EtherType tags
are: (1) 802.1Q, which represents the commonly used value of
0x8100. (2) vMAN, which represents the commonly used value of
0x88A8. (3) If EtherType is not one of these two values, it is a
custom tunnel value, representing any value in the range of 0 to
65535.
disabled
.
VLAN Commands
583