Ip Igmp Static-Group - Dell Z9500 Reference Manual

Usage Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
Information in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related ip access-list standard
Commands

ip igmp static-group

Configure an IGMP static group.
Syntax
ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group
address [exclude [source address]] | [include {source
address}]} command.
Parameters
group address
exclude source
address
include source
address
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Internet Group Management Protocol (IGMP)
— creates a standard access list to filter based on IP address.
Enter the group address in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keyword exclude then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
(OPTIONAL) Enter the keyword include then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
785