Hitachi Compute Blade 2000 User Manual page 374

Message
Single-bit overflow ECC errors were detected
during the previous boot of the RAID controller.
The DIMM on the controller needs replacement.
Please contact technical support to resolve this
issue. If you continue, data corruption can occur.
Press 'X' to continue or else power off the system
and replace the DIMM module and reboot. If you
have replaced the DIMM press 'X' to continue.
Multibit ECC errors were detected on the RAID
controller. If you continue, data corruption can
occur. Please contact technical support to resolve
this issue. Press 'X' to continue or else power off
the system, replace the controller and reboot.
Single-bit ECC errors were detected on the RAID
controller. Please contact technical support to
resolve this issue. Press 'X' to continue or else
power off the system, replace the controller and
reboot.
Single-bit overflow ECC errors were detected on
the RAID controller. If you continue, data
corruption can occur. Please contact technical
support to resolve this issue. Press 'X' to continue
or else power off the system, replace the
controller and reboot.
RAID Adapter Memory Error!!! Please check the
SDRAM connection. If problems persist contact
Tech Support. Press Any Key to Continue...
Adapter at Baseport XXXXh is not responding. No
MegaRAID Adapter installed.
This is a TEST message. You may hit a key to
ignore it, or wait 5 seconds. No further action is
required.
This firmware is an ALPHA version - It has not
completed all validations. The validation stamp is:
X Y.
This firmware is BETA version - It has not
completed all validations. The validation stamp is:
X Y.
This firmware is a TEST version - It has not
completed any validation.
Firmware version inconsistency was detected.
The adapter has recovered, but cached data was
lost.
The most recent configuration command could
not be committed and must be retried.
Previous configuration cleared or missing
Importing configuration created on X/Y X:Y
An enclosure was found that contains both SAS
and SATA drives, but this controller does not
allow mixed drive types in a single enclosure.
Please correct the problem then restart your
system.
Description
An error occurred on the disk array controller
memory. When this message is displayed, contact
your reseller or call maintenance personnel.
Baseport XXXXh does not respond. When this
message is displayed, contact your reseller or call
maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
Disk array configuration information was cleared or
not found.
When this message is displayed, contact your
reseller or call maintenance personnel.
The disk array controller is operated by incorrect
parameters. When this message is displayed,
contact your reseller or call maintenance
personnel.
323