Sflow Sample-Rate (Interface) - Dell S4810 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage Sample-rate is the average number of packets skipped before the sample is taken.
Information This command changes the global default sampling rate. You can configure an
interface to use a different sampling rate than the global sampling rate. If the value
entered is not a correct power of 2, the command generates an error message
with the previous and next power of 2 value. Select one of these two packet
numbers and re-enter the command.
Related

sflow sample-rate (Interface)

Commands
sflow sample-rate (Interface)
Change the interface default sampling rate.
S4810
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value
sFlow
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the interface sampling rate.
Enter the sampling rate value. For the C-Series and S-Series,
the range is from 256 to 8388608 packets. Enter values in
powers of 2 only; for example, 4096, 8192, 16384, etc. The
default is 32768 packets.
1549