General Specification - Electronic Instrument Cluster (Eic) - New Holland 200 Series Service Manual

General specification - Electronic Instrument Cluster (EIC)

L213
L216
The EIC is located on the right hand cab post.
Once in the seat, the alarm sounds and selected lamps illuminate briefly. Monitor these lamps on a daily basis to
confirm that they will function in the event of a system alarm. The fuel gauge and hour meter will remain illuminated
for operator monitoring.
When started, the machine will be in park with the PARK BRAKE lamp illuminated. The PARK BRAKE lamp is
located on the instrument cluster. The PARK BRAKE button switch is located on the right-hand control handle.
The operator must be in the seat with the seat belt fastened and the restraint bar lowered. The operator must push
the OPERATE button to activate the loader arms and ground drive, after the loader is started.
A semi-hidden SETUP menu allows the user to view, select, change and customize a number of machine settings. A
security code may be entered into the Instrument Cluster. Once the security code has been entered, each user will
have to enter the code before the machine will start. Contact your dealer for detailed information on the SETUP menu
and security feature activation.
NOTE: Fault code definitions are located in the troubleshooting section. The updated fault code is visible to the
operator on the display on the right-hand column.
NOTICE: Low hydraulic charge pressure will cause engagement of the park brake. With an Electro Hydraulic (EH)
control unit, the PARK BRAKE lamp will flash and an audible alarm will sound, if this condition exists.
INTRODUCTION
NA
NA
47712044 29/04/2014
20