Task 1: Definity Administration; Procedure To Configure Mapd In The Switch And Establish A Link - Avaya DEFINITY Manual

Task 1: DEFINITY Administration

Task 1: DEFINITY Administration
Task 1 is performed by the customer from the DEFINITY System Administration
Terminal (SAT). The objective of this task is to make sure the MAPD is set up
correctly in the switch and to administer a link.
NOTE:
Whenever you change the System-Parameters Customer-Options Form,
you must log out for the changes to take effect.
Procedure to Configure MAPD in the Switch
and Establish a Link
Step 1 of this procedure recommends using the change circuit packs command
instead of the display circuit packs command. By using the change form of the
command, you can effect changes if they are necessary
1. Log in to the DEFINITY system.
1. Type change circuit packs .
The system displays a CARRIER screen similar to Screen 2-1.
change circuit-packs 1
----------------------------------------------------------------------
Slot Code Sfx
01: _____
02: _____
03: _____
04: ASAIM1 RESERVED-LANGATE
05: ASAIM1 RESERVED-LANGATE
B
06: TN801
07: _____
08: _____
09: _____
10: _____
'#' indicates circuit pack conflict
Screen 3-1. Change Circuit-Packs, Carrier Screen
CARRIER 1A
Name
MAPD BOARD
Page 1 of 5
Slot Code Sfx
11: _____
12: _____
13: _____
14: _____
15: _____
16: _____
The entry for the MAPD
indicates that the system
fully recognizes the board
(no conflicts exist).
Issue 3 May 2002
Name
3-3