NEC Univerge SV8100 Features And Specifications Manual page 375

UNIVERGE SV8100
Program
Program Name
Number
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
20-11-17 Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
20-13-14 Class of Service Options
(Supplementary Service) –
Department Calling (PLT No
Called Extension)
22-02-01 Incoming Call Trunk Setup –
Incoming Type
22-07-01 DIL Assignment
24-02-05 System Options for Transfer –
Message Wait Ring Interval Time
24-02-08 System Options for Transfer –
Delayed Transfer Timer for All
Department Groups
24-05-01 Department Group Transfer Target
Setup
40-01-10 Department Group Call when the
Automated Attendant is activated
SV8100 Features and Specifications Manual
Description/Comments
Turns Off or On an extension ability
to have calls queued if a call rings
the extension when it is busy.
Turns Off or On an extension user
ability in a Department Group to use
the Trunk-to-Trunk Forwarding
service codes.
Allows a busy extension ability to
Manually (0) or Automatically (1)
receive Off-Hook signals.
Turns Off or On an extension user
ability to call a Department Group
Pilot.
If you want a trunk to be a DIL to a
Department Group, assign Service
Type 4 for each Night Service
Mode. Refer to Program 22-07-01.
For each trunk assigned Service
Type 4 in Program 22-02-01 above,
assign the DIL destination as the
Department Group pilot number (as
assigned in Program 11-07-01).
For Single Line Telephones (SLTs)
without message waiting lamps, this
is the time between intermittent
ringing. If this value is set to 0, the
system rings once.
Determine the time a call should
ring a Department Group before
transferring the call.
Assign the Speed Dial bin to each
Department Group to hold the
destination for the immediate
automatic transfer of ICM and
transferred calls to the Department
Group feature.
Used to Enable or Disable
Department Group Call when the
Automated Attendant is activated.
Assigned Data
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Extension Number
(maximum eight digits)
(default not assigned)
0~64800 (seconds)
(default = 30 seconds)
0~64800 (seconds)
(default = 10 seconds)
0~1999
(default = 1999)
0 = Disabled (Off)
1 = Enabled (On)
(Default = 0)
Issue 1.0
Level
1 2 3
2 - 351