Toyota T100 1996 Service Manual page 737

EM−14
Lock Bolt
Pivot Bolt
P14907
1996 TOYOTA T100 (RM449U)
ENGINE MECHANICAL (3RZ−FE)
REMOVAL
1.
2.
3.
4.
Remove the 4 bolts and engine under cover.
5.
Loosen the idler pulley nut and adjusting bolt, and remove the
Adjusting Bolt drive belt.
6.
(a)
(b)
(c)
P14842
(d)
(e)
(f)
7.
(a)
HINT:
Put a side the compressor, and suspend it.
(b)
P14935
8.
(a)
(b)
(c)
A03721
9.
(a)
(b)
P14953
− TIMING CHAIN
DRAIN ENGINE OIL
DRAIN ENGINE COOLANT
REMOVE CYLINDER HEAD
(See page EM−28)
REMOVE ENGINE UNDER COVER
w/ A/C:
REMOVE A/C COMPRESSOR DRIVE BELT
REMOVE DRIVE BELT, FAN WITH FLUID
COUPLING, WATER PUMP PULLEY AND FAN
SHROUD
Stretch the belt and loosen the water pump pulley mount-
ing nuts.
Loosen the lock, pivot and adjusting bolts of the genera-
tor, and remove the drive belts.
Remove the 4 water pump pulley mounting nuts.
Pull out the fan with fluid coupling and water pump pulley.
Remove the No.2 fan shroud.
Remove the 4 bolts and No.1 fan shroud.
w/ A/C:
DISCONNECT A/C COMPRESSOR AND BRACKET
Remove the 4 mounting bolts, and disconnect the com-
pressor from the bracket.
Remove the 4 bolts and A/C compressor bracket.
REMOVE GENERATOR, ADJUSTING BAR AND
BRACKET
Remove the lock, pivot bolts and the generator.
Remove the bolt and adjusting bar.
Remove the 3 bolts and bracket.
REMOVE CRANKSHAFT POSITION SENSOR
Remove the 2 bolts and crankshaft position sensor.
Remove the O−ring from the crankshaft position sensor.
EM06Z−03