D-Link DXS-3600 Series Reference Manual page 1015

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# interface eth1/0/1
Switch(config-if)# qcn cp 1 set-point 30000
Switch(config-if)# qcn cp 1 weight 1
Switch(config-if)# qcn cp 1 sample-base 160000
Switch(config-if)# qcn cp 1 min-header-octets 10
Switch(config-if)#
83-7 show qcn cnpv
This command is used to display the QCN CNPV settings and status.
show qcn cnpv [status]
Parameters
status
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configured QCN CNPV configuration.
Example
This example shows how to display the QCN CNPV settings.
Switch# show qcn cnpv
Dot1p
Priority Queue ID Mode Choice Defense Mode
-------- -------- ----------- -------------- --------- --------- -----------
1
2
Switch#
This example shows how to display the total discarded frames, auto-alternate priority, and error port list
for all CNPVs.
Switch# show qcn cnpv status
QCN Status
QCN Discarded Frames
CNM Transmit Priority
CNPV: 1
(Optional) Specifies to display the total discarded frames, auto-
alternate priority, and error port list for the CNPV.
Defense Admin
3 admin interior
4 auto interior-ready
: Enabled
: 1234
: 1
Alternate Auto Alt. CP
Priority
0
0
1015
Priority Creation
0 enable
0 disable