D-Link DXS-3600 Series Reference Manual page 1109

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
linkdown
coldstart
warmstart
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command controls the sending of SNMP standard notification traps. To enable the sending of
notification traps, the global setting must be enabled too.
Example
This example shows how to enable the router to send all SNMP traps to the host 10.9.18.100 using the
community string defined as public.
Switch# configure terminal
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server enable traps snmp
Switch(config)# snmp-server host 10.9.18.100 version 2c public
Switch(config)#
This example shows how to enable the SNMP authentication traps.
Switch# configure terminal
Switch(config)# snmp-server enable traps snmp authentication
Switch(config)#
95-8 snmp-server location
This command is used to configure the system's location information Use the no command to remove the
setting.
snmp-server location TEXT
no snmp-server location
Parameters
location TEXT
Default
(Optional) Specifies to control the sending of SNMP linkDown
notifications. A linkDown (2) trap is generated when the device
recognizes a failure in one of the communication links.
(Optional) Specifies to control the sending of SNMP coldStart
notifications.
(Optional) Specifies to control the sending of SNMP warmStart
notifications.
Specifies the string that describes the system location information. The
maximum length is 255 characters. The syntax is a general string that
allows spaces.
1109