D-Link DXS-3600 Series Reference Manual page 1136

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the Spanning Tree configuration for the single spanning tree when in the
RSTP or STP-compatible mode.
Example
This example shows how to display the spanning tree information when STP is enabled.
Switch# show spanning-tree
Protocol state: Enabled
protocol mode: RSTP
NNI BPDU Address: Dot1d(01-80-C2-00-00-00)
Root ID Priority
Address
Hello Time
Bridge ID Priority
Address
Hello Time
Topology Changes Count : 0
Interface
---------
eth1/0/3
eth1/0/5
eth1/0/6
eth1/0/7
Switch#
97-3 show spanning-tree configuration interface
This command is used to display the information about STP interface related configuration.
show spanning-tree configuration interface [INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
: 4096
: 00-04-9B-78-08-00
: 2 sec, Max Age: 20 sec, Forward Delay: 15 sec
: 4096 (priority 4096 sys-id-ext 0)
: 00-04-9B-78-08-00
: 2 sec, Max Age: 20 sec, Forward Delay: 15 sec
Role State
----- -----
designated forwarding 20000
backup blocking
backup blocking
root forwarding 2000
Specifies the interface ID to display.
Priority
Cost .Port# Type
------ --------- ------
128.3 p2p
200000 128.5 p2p
200000 128.6 shared
128.7 P2p
1136
Link
Edge
--------
non-edge
non-edge
non-edge
non-edge