D-Link DXS-3600 Series Reference Manual page 1100

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
self EMAIL-ADDRESS
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the email address that represents the switch. Only one email address can
be configured for this switch.
Example
This example shows how to configure the switch's email sender address as switch@domain.com.
Switch# configure terminal
Switch(config)# smtp self switch@domain.com
Switch(config)#
94-3 smtp recipient
This command is used to configure the recipient where the email will be sent. Use the no form of the
command to remove a recipient.
smtp recipient EMAIL-ADDRESS
no smtp recipient {all | EMAIL-ADDRESS}
Parameters
recipient EMAIL-ADDRESS
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The system provides the service to send SYSLOG messages to email receivers via SMTP. Use the smtp
recipient command to configure the email address to receive the email message. By default, no
messages will be sent. Use the logging smtp command to enable the sending of SYSLOG messages to
the email recipients and configure the filtering criteria.
Example
This example shows how to add the receiver mail address as receiver@domain.com.
Switch# configure terminal
Specifies the email address that which represents the switch.
Specifies a recipient to receive the email.
1100