D-Link DXS-3600 Series Reference Manual page 1048

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ip rip v2-broadcast
no ip rip v2-broadcast
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
RIP version 2 improves version 1 by sending multicast packets instead of broadcast packets in order to
reduce the load on unnecessary hosts on the LAN to process the broadcast packet.
Use this command to broadcast RIP version 2 updates to devices that do not listen to multicast packets. If
enabled, version 2 packets will be sent to the IP broadcast address instead of the IP multicast address
224.0.0.9.
Example
This example shows how to configure the interface VLAN 100 to broadcast version 2 RIP packets.
Switch# configure terminal
Switch(config)# interface
Switch(config-if)# ip rip send version 2
Switch(config-if)# ip rip v2-broadcast
Switch(config-if)#
87-9 network
This command is used to specify a network as one that runs RIP. To remove an entry, use the no form of
this command.
network NETWORK-PREFIX
no network NETWORK-PREFIX
Parameters
NETWORK-PREFIX
Default
None.
Command Mode
Router Configuration Mode.
Router Address Family Configuration (RIP) Mode.
vlan100
Specifies the subnet prefix of the network.
1048