D-Link DXS-3600 Series Reference Manual page 1164

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
auto-select
rj45
sfp
Default
By default, this option is set as auto-select.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can only be applied to combo ports.
Example
This example shows how to configure the media type for interface eth1/1/1 to RJ45.
Switch# configure terminal
Switch(config)# interface eth1/1/1
Switch(config-if)# media-type rj45
Switch(config-if)#
102-4 mdix
This command is used to configure the port Media-Dependent Interface Crossover (MDIX) state. Use the
no form of command to revert to the default setting.
mdix {auto | normal | cross}
no mdix
Parameters
auto
normal
cross
Default
By default, this option is set as auto.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies that the media type is selected based on the connection.
Specifies that the RJ45 media type is selected for the connection.
SFP/SFP+ connection is disabled.
Specifies that the SFP/SFP+ media type is selected for the connection.
RJ45 connection is disabled.
Specifies to set the port interface's MDIX state to the auto-MDIX mode.
Specifies to force the port interface's MDIX state to the normal mode.
Specifies to force the port interface's MDIX state to the cross mode.
1164