Ipv6 Rip Enable - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-rtr)#

88-4 ipv6 rip enable

This command is used to enable an IPv6 RIP routing process on an interface. To disable an IPv6 RIP
routing process on an interface, use the no form of this command.
ipv6 rip enable
no ipv6 rip enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable IPv6 RIP on required interfaces.
Example
This example shows how to enable the IPv6 RIP routing process on VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 rip enable
Switch(config-if)#
88-5 ipv6 rip metric-offset
This command is used to set the value to be added to the metric of an IPv6 RIP route received on the
configured interface. Use the no form of the command to restore the default setting.
ipv6 rip metric-offset METRIC-VALUE
no ipv6 rip metric-offset
Parameters
METRIC-VALUE
Default
By default, this value is 1.
Specifies the value to be added to the metric of an IPv6 RIP route
received on the configured interface. The valid range is from 1 to 16.
1058