D-Link DXS-3600 Series Reference Manual page 1156

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Total Entries: 6
Switch#
This example shows how to display all interface settings for the range from port 3/0/1 to port 3/0/2.
Switch# show storm-control interface eth3/0/1-2
Polling Interval
Trap
Interface
---------------------- --------------------------------------------
eth3/0/1
eth3/0/1
eth3/0/1
eth3/0/2
eth3/0/2
eth3/0/2
Total Entries: 6
Switch#
Display Parameters
Interface
Action
Threshold
Current
State
: 15 sec
: Disabled
Storm Action
Broadcast Drop
Multicast Drop
Unicast Drop
Broadcast Shutdown
Multicast Shutdown
Unicast Shutdown
The interface ID.
The configured action, the possible actions are: Drop, Shutdown,
None.
The configured threshold.
The actual traffic rate which is currently flowing though the interface.
Its unit may be percentage, kbps, PPS based on the configured meter
mode. Because hardware can only counts by PPS, this value of this
filed may be a rough value for percentage and kbps.
The current state of storm control on a given interface for a given traffic
type. The possible states are:
Forwarding: No storm event has been detected.
Dropped: A storm event has occurred and the storm traffic exceeding
the threshold is dropped.
Error Disabled: The port is disabled due to a storm.
Link Down: The port is physically linked down.
Inactive: Indicates that storm control is not enabled for the given traffic
type.
Shutdown Retries
Threshold
80/64 %
80/64 %
80/64 %
500/300 pps
500/300 pps
500/300 pps
1156
: Infinite
Current State
50% Forwarding
50% Forwarding
50% Forwarding
- Error Disabled
- Error Disabled
- Error Disabled