D-Link DXS-3600 Series Reference Manual page 1143

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
stp
Default
By default, this mode is RSTP.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the mode is configured as STP or RSTP, all currently running MSTP instances will be cancelled
automatically. If the newly configured mode is changed from the previous one, the spanning-tree state
machine will restart again, therefore all of the stable spanning-tree port states will transit into discarding
states.
Example
This example shows how to configure the running version of the STP module to RSTP.
Switch# configure terminal
Switch(config)# spanning-tree mode rstp
Switch(config)#
97-12 spanning-tree portfast
This command is used to specify the port's fast mode. Use the no form of the command to revert to the
default setting.
spanning-tree portfast {disable | edge| network}
no spanning-tree portfast
Parameters
disable
edge
network
Default
By default, this option is network.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A port can be in one of the following three port fast modes:
Specifies the Spanning Tree Protocol (IEEE 802.1D Compatible)
Specifies to set the port to the port fast disabled mode.
Specifies to set the port to the port fast edge mode.
Specifies to set the port to the port fast network mode.
1143