D-Link DXS-3600 Series Reference Manual page 1118

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
ENGINEID-STRING
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
An SNMP engine ID is not displayed or stored in the running configuration. The SNMP engine ID is a
unique string to identify the device. A string is generated by default. If you configure a string less than 24
characters, it will be filled with trailing zeros up to 24 characters.
Example
This example shows how to configure the SNMP engine ID to 332200000000000000000000.
Switch# configure terminal
Switch(config)# snmp-server engineID local 3322
Switch(config)#
95-18 snmp-server group
This command is used to configure an SNMP group. Use the no command to remove a SNMP group or
remove a group from using a specific security model.
snmp-server group GROUP-NAME {v1 | v2c | v3 {auth | noauth | priv}} [read READ-VIEW] [write
WRITE-VIEW] [notify NOTIFY-VIEW] [access IP-ACL-NAME]
no snmp-server group GROUP-NAME {v1 | v2c | v3 {auth | noauth | priv}}
Parameters
GROUP-NAME
v1
v2c
v3
auth
noauth
priv
read READ-VIEW
write WRITE-VIEW
notify NOTIFY-VIEW
Specifies the engine ID string of a maximum of 24 characters.
Specifies the group name of a maximum of 32 characters. The syntax
is general string that does not allow space.
Specifies that the group user can use the SNMPv1 security model.
Specifies that the group user can use the SNMPv2c security model.
Specifies that the group user can use the SNMPv3 security model.
Specifies to authenticate the packet but not encrypt it.
Specifies not to authenticate and not to encrypt the packet.
Specifies to authenticate and encrypt the packet.
(Optional) Specifies a read-view that the group user can access.
(Optional) Specifies a write-view that the group user can access.
(Optional) Specifies a write-view that the group user can access. The
1118