D-Link DXS-3600 Series Reference Manual page 1088

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
92-4 crypto pki certificate chain
This command is used to enter into the certificate chain configuration mode.
crypto pki certificate chain NAME
Parameters
NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter into certificate chain configuration mode. If the specified trust-point name
doesn't exist, an error message will be displayed.
Example
This example shows how to enter into certificate chain configuration mode.
Switch# configure terminal
Switch(config)# crypto pki certificate chain TP1
Switch(trustpoint)#
92-5 primary
This command is used to assign a specified trust-point as the primary trust-point of the switch.
primary
no primary
Parameters
None.
Default
By default, this option is disabled.
Command Mode
CA-Trust-Point Configuration Mode.
Command Default Level
Level: 12.
Specifies the name for the trust-point.
1088