D-Link DXS-3600 Series Reference Manual page 1072

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
show cpu-protect sub-interface {manage | protocol | route} [UNIT-ID]
Parameters
UNIT-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configured rate limit and drop count of the safeguard engine of a specific
group. These counters are counted by the software.
Example
This example shows how to display the configured rate limit and drop count of the safeguard engine of a
specific group.
Switch# show cpu-protect sub-interface manage
Sub-Interface: manage
Rate Limit : 1000 pps
Unit
--------------
1
3
Switch#
89-7 show cpu-protect type
This command is used to display the rate limit and statistics of CPU protection.
show cpu-protect type {PROTOCOL-NAME [UNIT-ID] | unit UNIT-ID}
Parameters
PROTOCOL-NAME [UNIT-ID]
unit UNIT-ID
Default
(Optional) Specifies the unit ID to display the rate limit configuration
and statistics by sub-interface.
Total Drop
--------- ---------
50 0
50 0
Specifies that the configured rate limit and statistics of the specified
protocol on the CM-card and all existing IO-cards will be displayed if
the optional unit ID is not specified. Otherwise, only the information on
the specified unit ID will be displayed.
Specifies the unit ID to display the rate limit configuration and
statistics.
1072