Sflow Poller - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The user can only specify a receiver that has its owner name setup. If the receiver associated with the
sampler has its owner name reset, the sampler will be reset to the default setting. The receiver ID of a
default sampler is 0.
The user can configure an instance's mode to either inbound or outbound. If not specified, the default
mode is inbound which will monitor the ingress packets.
An interface can be configured with multiple samplers. If multiple samplers are configured, the configured
sampling rate can be different. But the sampling rate of all other samplers in the same direction must be
multiples in power of 2 of the minimal configured sampling rate.
The sampling rate in operation may be automatically adjusted to a lower rate when the system is
overloading.
Example
This example shows how to create the sampler of instance 1 with the receiver as 1, inbound, rate as 1024
and size as 128 bytes.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# sflow sampler 1 receiver 1 inbound sampling-rate 1024 max-header-
size 128
Switch(config-if)#

93-3 sflow poller

This command is used to create or configure a poller for the sFlow agent. Use the no form of this
command to delete a poller.
sflow poller INSTANCE [receiver RECEIVER] [interval SECONDS]
no sflow poller INSTANCE
Parameters
INSTANCE
receiver RECEIVER
interval SECONDS
Default
By default, no poller is created.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command without keywords to create a default poller or to reset an existing poller to default
values. Use the no form of this command with an instance to delete one poller.
Specifies the instance index if multiple pollers are associated with one
interface. The range is from 1 to 65535.
(Optional) Specifies the receiver's index for this poller. If not specified,
the value is 0. The user cannot configure the value to 0.
(Optional) Specifies the maximum number of seconds between
successive polling samples. The range is from 0 to 120. 0 means
disable. If not specified, the default is 0.
1095