The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable loopdetect
disable loopdetect
config loopdetect mode
config loopdetect ports
config loopdetect
show loopdetect
Each command is listed in detail, as follows:
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the loopback detection feature on the Switch:
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
LOOPBACK DETECTION COMMANDS
Parameter
[portbase | vlanbase]
[<portlist> | all] state [enable | disable]
interval_time <value 1-32767> lbd_recover_time [0 | <value 60-1000000>]
{ports [<portlist> | all]}
To enable the loop back detection on the Switch.
enable loopdetect
The enable loopdetect command enables the loop back detection
on the Switch.
None.
Only administrator -level users can issue this command.
DGS-1210-28P/ME:5# enable loopdetect
Command: enable loopdetect
Success.
DGS-1210-28P/ME:5#
To disable the loop back detection on the Switch.
disable loopdetect
The disable loopdetect command disables the loop back detection
on the Switch.
None.
Only administrator-level users can issue this command.
51
10