D-Link DXS-3600 Series Reference Manual page 995

Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs Also See for DXS-3600 Series:
Table of Contents

Advertisement

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
The specified limitation cannot exceed the maximum speed of the specified interface. For the ingress
bandwidth limitation, the ingress will send a pause frame or a flow control frame when the received traffic
exceeds the limitation.
Example
This example shows how the maximum bandwidth limits are configured on eth2/0/5. The ingress
bandwidth is limited to 2000Kbps and 4096K bytes for burst traffic.
Switch# configure terminal
Switch(config)# interface eth2/0/5
Switch(config-if)# rate-limit input 2000 4096
Switch(config-if)#
82-20
service-policy
This command is used to attach a policy map to an input interface. To remove a service policy from an
input interface, use the no form of this command.
service-policy {input | output} NAME
no service-policy {input | output}
Parameters
input
output
NAME
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the service-policy command to attach at most one policy map for each type (input or output) on an
interface. This policy is attached to the interface for aggregate and controls the number or rate of packets.
A packet arriving at a port will be treated based on the service policy attached to the interface.
Example
This example shows how two policy maps are defined: (1) cust1-classes and (2) cust2-classes.
For cust1-classes, gold is configured to match CoS 6 and be policed by a single rate policer with a
committed rate of 800 Kbps. Silver is configured to match CoS 5 and be policed by a single rate policer
with a committed rate of 2000Kbps, and bronze is configured to match CoS 0 and be policed by a single
rate policer with a committed rate of 8000Kbps.
Specifies to apply the policy map for ingress flow on the interface.
Specifies to apply the policy map for egress flow on the interface.
Specifies the name of a service policy map. The name can be a
maximum of 31 alphanumeric characters.
995

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxs-3600-32s

Table of Contents