D-Link DXS-3600 Series Reference Manual page 1061

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this option is disabled.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the metric option is not specified or specified as 0, the following rules are applied:
•
The metric of the redistributed static route or connected route will be 1, if the metric option is not
specified, or is specified as 0.
•
The metric of the redistributed route from other protocols to RIP process will be determined by the
default metric command if the metric option is not specified.
•
The metric of the redistributed route from other protocols to RIP process will be 1 if the metric
option is specified as 0.
If the default metric is not specified, then the original metric from the redistributed protocol will be
transparently carried through.
Example
This example shows how to configure the specified OSPF process routes to be redistributed into an RIP
domain. The metric will be remapped to 10.
Switch# configure terminal
Switch(config)# ipv6 router rip
Switch(config-rtr)# redistribute ospf
Switch(config-rtr)#
88-9 show ipv6 rip
This command is used to display interface specific information for RIP.
show ipv6 rip [database]
Parameters
database
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configuration information of RIP protocol.
Use the show ipv6 rip database command to display the entry in the RIP routing database.
Example
metric 10
(Optional) Specifies to display the entry in the RIP routing database.
1061