D-Link DXS-3600 Series Reference Manual page 1142

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
97-10 spanning-tree link-type
This command is used to configure a link-type for a port. To return to the default settings, use the no form
of this command.
spanning-tree link-type {point-to-point | shared}
no spanning-tree link-type
Parameters
point-to-point
shared
Default
The link type is automatically derived from the duplex setting unless explicitly configuring the link type.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A full-duplex port is considered to have a point-to-point connection; on the opposite, a half-duplex port is
considered to have a shared connection .The port can't transit into forwarding state rapidly by setting link
type to shared-media. Hence, auto-determined of link-type by the STP module is recommended.
This configuration will take effect for all the spanning-tree modes.
Example
This example shows how to configure the link type to point-to-point for port eth1/0/7.
Switch# configure terminal
Switch(config)# interface eth1/0/7
Switch(config-if)# spanning-tree link-type point-to-point
Switch(config-if)#
97-11 spanning-tree mode
This command is used to configure the STP mode. To return to the default settings, use the no form of
this command.
spanning-tree mode {mstp | rstp |stp}
no spanning-tree mode
Parameters
mstp
rstp
Specifies that the port's link type is point-to-point.
Specifies that the port's link type is a shared media connection.
Specifies the Multiple Spanning Tree Protocol (MSTP).
Specifies the Rapid Spanning Tree Protocol (RSTP).
1142