D-Link DXS-3600 Series Reference Manual page 1108

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to enable the sending of trap packets globally. Use the no command to disable the
sending of trap packets.
snmp-server enable traps
no snmp-server enable traps
Parameters
None.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enables the device to send the SNMP notification traps globally. To configure the router to
send these SNMP notifications, enter the snmp-server enable traps command to enable the global
setting.
Example
This example shows how to enable the SNMP traps global sending state.
Switch# configure terminal
Switch(config)# snmp-server enable traps
Switch(config)#
95-7 snmp-server enable traps snmp
This command is used to enable the sending of all or specific SNMP notifications. To disable sending of
all or specific SNMP notifications, use the no form of this command.
snmp-server enable traps snmp [authentication] [linkup] [linkdown] [coldstart] [warmstart]
no snmp-server enable traps snmp [authentication] [linkup] [linkdown] [coldstart] [warmstart]
Parameters
authentication
linkup
(Optional) Specifies to control the sending of SNMP authentication
failure notifications. An authenticationFailuretrap is generated when
the device receives an SNMP message that is not properly
authenticated. The authentication method depends on the version of
SNMP being used. For SNMPv1 or SNMPv2c, authentication failure
occurs if packets are formed with an incorrect community string. For
SNMPv3, authentication failure occurs if packets are formed with an
incorrect SHA/MD5 authentication key.
(Optional) Specifies to control the sending of SNMP linkUp
notifications. A linkup (3) trap signifies is generated when the device
recognizes that one of the communication links has come up.
1108