Show Ip Interface - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide
Example
This example shows how to display system boot information.
Switch#show boot
Unit 1
Boot image: /c:/Image1
Boot config: /c:/Config1
Switch#
2-25

show ip interface

This command is used to display the IP interface information.
show ip interface [INTERFACE-ID] [brief]
Parameters
INTERFACE-ID
brief
Default
None.
Command Mode
EXEC Mode.
Any Configuration Mode.
Usage Guideline
If no parameter is specified, information for all the interfaces will be displayed.
Example
This example shows how to display the brief information of the IP interface.
Switch#show ip interface brief
Interface IP Address
---------- ---------------
vlan1 10.90.90.90
Total Entries: 1
Switch#
(Optional) Specifies to display information for the specified IP interface.
(Optional) Specifies to display a summary of the IP interface information.
Link Status
-----------
up
25