ip multicast querier-forwarding
Enables or disables IGMP querier forwarding on the specified VLAN or on the system if no VLAN is
specified.
ip multicast [vlan vid] querier-forwarding [{enable | disable}]
no ip multicast [vlan vid] querier-forwarding
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove an IGMP querier forwarding entry on the specified VLAN
or on the system and return to its default behavior.
•
If the IGMP querier forwarding is already enabled on the system, then the VLAN configuration will
override the system's configuration.
•
IGMP querier forwarding refers to promoting detected IGMP queriers to receive all IP multicast data
traffic.
Examples
-> ip multicast querier-forwarding enable
-> ip multicast querier-forwarding disable
-> ip multicast querier-forwarding
-> ip multicast vlan 2 querier-forwarding enable
-> ip multicast vlan 2 querier-forwarding disable
-> ip multicast vlan 2 querier-forwarding
-> no ip multicast vlan 2 querier-forwarding
Release History
Release 6.3.1; command was introduced.
page 27-6
The VLAN on which configuration is applied.
Enable IGMP querier forwarding.
Disable IGMP querier forwarding.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide
June 2012