Dell PowerEdge M420 Reference Manual page 127

Command
ip multicast
ip multicast ttl-threshold
ip pim
ip pim bsr-border
ip pim bsr-candidate
ip pim dense
ip pim dr-priority
ip pim hello-interval
ip pim join-prune-interval
ip pim register-rate-limit
ip pim rp-address
ip pim rp-candidate
ip pim sparse
ip pim ssm
Description
Sets the administrative mode of the IP
multicast forwarder in the router to active.
ttlvalue
Applies a to a routing interface.
Administratively configures PIM mode for IP
multicast routing on a VLAN interface.
Administratively disables bootstrap router
(BSR) messages from being sent or received
through an interface.
Configures the router to advertise itself as a
bootstrap router (BSR).
Administratively configures PIM dense mode
for IP multicast routing.
Administratively configures the advertised
designated router (DR) priority value.
Administratively configures the PIM Hello
messages on the specified interface.
Administratively configures the frequency of
join/prune messages on the specified interface.
Sets a limit on the maximum number of PIM
register messages sent per second for each (S,G)
entry.
Defines the address of a PIM RP for a specific
multicast group range.
Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP) for a specific multicast
group range.
Administratively configures PIM sparse mode
for IP multicast routing.
Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
Command Groups
a
Mode
GC
IC
IC
IC
GC
GC
IC
IC
IC
GC
GC
IC
GC
GC
127