Dell PowerEdge M420 Reference Manual page 175

Management Access List — Contains commands to define management
•
access administration lists. The Global Configuration mode command
management access-list is used to enter the Management Access List
configuration mode.
• Policy-map — Use the policy-map command to access the QoS policy
map configuration mode to configure the QoS policy map.
• Policy Class — Use the class command to access the QoS Policy-class
mode to attach or remove a diffserv class from a policy and to configure
the QoS policy class.
• Class-Map — This mode consists of class creation/deletion and matching
commands. The class matching commands specify layer 2, layer 3 and
general match criteria. Use the class-map class-map-name commands to
access the QoS Class Map Configuration mode to configure QoS class
maps.
• Stack — Use the stack command to access the Stack Configuration Mode.
• Ethernet — Contains commands to manage Ethernet port configuration.
The Global Configuration mode command interface enters the Interface
Configuration mode to configure an Ethernet interface.
• Port Channel — Contains commands to configure port-channels, i.e.,
assigning ports to a port-channel. Most of these commands are the same as
the commands in the Ethernet interface mode and are used to manage the
member ports as a single entity. The Global Configuration mode
command interface port-channel
the Port Channel mode.
Tunnel — Contains commands to manage tunnel interfaces. The Global
•
Configuration mode command interface tunnel enters the Tunnel
Configuration mode to configure an tunnel type interface.
Loopback — Contains commands to manage loopback interfaces. The
•
Global Configuration mode command interface loopback enters the
Loopback Configuration mode to configure an loopback type interface.
• SSH Public Key-chain — Contains commands to manually specify other
switch SSH public keys. The Global Configuration mode command crypto
key pub-key chain ssh is used to enter the SSH Public Key-chain
configuration mode.
port-channel-number is used to enter
Using the CLI
175