Routing Information Protocol - Dell PowerEdge M420 Reference Manual

Command
ip irdp minadvertinterval
ip irdp multicast
ip irdp preference
show ip irdp
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.

Routing Information Protocol

Command
auto-summary
default-information
originate
default-metric
distance rip
distribute-list out
enable
hostroutesaccept
ip rip
ip rip authentication
ip rip receive version
Description
Configures the minimum time, in seconds,
allowed between sending router advertisements
from the interface.
Sends router advertisements as IP multicast
packets.
Configures the preference of the address as a
default router address relative to other router
addresses on the same subnet.
Displays the router discovery information for all
interfaces, or for a specified interface.
Description
Enables the RIP auto-summarization mode.
Controls the advertisement of default routes.
Sets a default for the metric of distributed
routes.
Sets the route preference value of RIP in the
router.
Specifies the access list to filter routes received
from the source protocol.
Resets the default administrative mode of RIP
in the router (active).
Enables the RIP hostroutesaccept mode.
Enables RIP on a router interface.
Sets the RIP Version 2 Authentication Type and
Key for the specified interface.
Configures the interface to allow RIP control
packets of the specified version(s) to be
received.
Command Groups
a
Mode
IC
IC
IC
PE
a
Mode
RIP
RIP
RIP
RIP
RIP
RIP
RIP
IC
IC
IC
137