Traffic Class Group Configuration Mode; Tunnel Group Configuration Mode; Tunnel Group Tunnel Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Traffic Class Group Configuration Mode

Tunnel Group Configuration Mode

Tunnel Group Tunnel Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
In this mode, you can create and configure traffic-class groups, which can contain multiple
traffic classes.
From Global Configuration mode, type the traffic-class-group command and a
trafficClassGroupName, and press Enter.
host1(config)#traffic-class-group trafclasnameabcd
host1(config-traffic-class-group)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
traffic-class Set the traffic class belong to this group
In this mode, you can define up to 31 tunnels for a tunnel group.
From Global Configuration mode, type aaa tunnel-group and the groupName, and press
Enter.
host1(config)#aaa tunnel-group storm
host1(config-tunnel-group)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure tunnel tag
In this mode, you can configure attributes for a tunnel group tunnel.
From Tunnel Group Configuration mode, type tunnel and the tag number (in the range
1–31) for the tunnel, and press Enter.
host1(config-tunnel-group)#tunnel 1
host1(config-tunnel-group-tunnel)#?
address Configure tunnel endpoint address
client-name Configure the client hostname of the tunnel
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
identification Configure tunnel identification
log Configure logging settings
Chapter 2: Command-Line Interface
113