Window Watchdog (Wwdg); Wwdg Introduction; Wwdg Main Features; Wwdg Functional Description - ST STM32F100 Series Reference Manual

Advanced arm-based 32-bit mcus
Hide thumbs Also See for STM32F100 Series:
Table of Contents

Advertisement

RM0041
19

Window watchdog (WWDG)

Low-density value line devices are STM32F100xx microcontrollers where the flash
memory density ranges between 16 and 32 Kbytes.
Medium-density value line devices are STM32F100xx microcontrollers where the flash
memory density ranges between 64 and 128 Kbytes.
High-density value line devices are STM32F100xx microcontrollers where the flash
memory density ranges between 256 and 512 Kbytes.
This section applies to the whole STM32F100xx family, unless otherwise specified.
19.1

WWDG introduction

The window watchdog is used to detect the occurrence of a software fault, usually
generated by external interference or by unforeseen logical conditions, which causes the
application program to abandon its normal sequence. The watchdog circuit generates an
MCU reset on expiry of a programmed time period, unless the program refreshes the
contents of the downcounter before the T6 bit becomes cleared. An MCU reset is also
generated if the 7-bit downcounter value (in the control register) is refreshed before the
downcounter has reached the window register value. This implies that the counter must be
refreshed in a limited window.
19.2

WWDG main features

Programmable free-running downcounter
Conditional reset
Early wakeup interrupt (EWI): triggered (if enabled and the watchdog activated) when
the downcounter is equal to 0x40.
19.3

WWDG functional description

If the watchdog is activated (the WDGA bit is set in the WWDG_CR register) and when the
7-bit downcounter (T[6:0] bits) rolls over from 0x40 to 0x3F (T6 becomes cleared), it initiates
a reset. If the software reloads the counter while the counter is greater than the value stored
in the window register, then a reset is generated.
Reset (if watchdog activated) when the downcounter value becomes less than
0x40
Reset (if watchdog activated) if the downcounter is reloaded outside the window
(see
Figure
201)
RM0041 Rev 6
Window watchdog (WWDG)
487/709
493

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STM32F100 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents