Engine Start Button; Multifunction Lever - BRP can-am COMMANDER 2017 Series Operator's Manual

SECONDARY CONTROLS
Digitally Encoded Security System
(D.E.S.S.)
The ignition keys contain an electronic
circuit that gives it a unique electronic
serial number.
The D.E.S.S. system reads the key
code and allows engine starting for
keys it recognizes.

2) Engine Start Button

The engine start button is located on
the upper console. When pressed and
held, it starts the engine.
NOTE: The ignition switch must be in
the ON position to allow engine start.
NOTE: If the ignition switch is left
ON for more than 15 minutes, engine
will not start unless ignition switch is
turned OFF, then ON again.
tmo2014-002-004_b
TYPICAL
1. Engine start button
______________
50

3) Multifunction Lever

Low/High Beam Selection
tmo2014-002-003_b
1. Multifunction lever
When the multifunction lever is in the
middle position, the low beam is se-
lected.
Push the multifunction lever forward to
select high beam.
Pull back the multifunction lever to re-
turn to low beam.
NOTE: The ignition switch must be set
to ON with lights position to turn on the
headlights.
Headlight Flashing
To flash the high beams while in low
beams, pull on the multifunction lever.
Horn Activation
The horn can be activated by pushing
the end of the multifunction lever to-
ward the steering wheel.
Turn Signal Activation
To activate the LH turn signals, push
down the multifunction lever.
To activate the RH turn signals, push up
the multifunction lever.
Reposition the multifunction lever in
the middle position to stop turn signal.