Ignition Switch And Keys - BRP can-am RENEGADE 500 2015 Operator's Manual

P: Park
The park position locks the gearbox to
help prevent vehicle movement.
WARNING
Always use the PARK (P) position
when the vehicle is not in oper-
ation. The vehicle can roll if the
shift lever is not set to P (PARK).
R: Reverse
The reverse position allows the vehicle
to go backwards.
NOTE: In reverse operation, the en-
gine's RPM is limited, thus limiting the
vehicle reverse speed.
WARNING
When driving downhill in reverse,
gravity can increase the vehicle
speed above the set limited re-
verse speed.
Neutral
The neutral position disengages the
gearbox.
WARNING
Always use the PARK (P) position
when the vehicle is not in oper-
ation. The vehicle can roll if the
shift lever is set to N (NEUTRAL).
High Range (Forward)
This position selects the high speed
range of the gearbox. It is the normal
driving speed range. It allows the vehi-
cle to reach its maximum speed.
Low Range (Forward)
This position selects the low speed
range of the gearbox. It allows the ve-
hicle to move slowly with maximum
torque at the wheels.
NOTICE
to pull a trailer, carry heavy cargo,
go over obstacles or drive uphill and
downhill.
7) Ignition Switch and
Keys
The ignition switch is located on the LH
side of the central panel below the han-
dlebar.
vmo2012-014-001_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON "with light"
3. ON "without light"
OFF
The key can be inserted or removed in
this position only.
In OFF position, the electrical system
of the vehicle is disabled.
The engine is shut down by turning the
ignition switch to OFF position.
NOTE: While the engine can be
stopped by turning the ignition key to
OFF position, we recommend the en-
gine be stopped by setting the emer-
gency engine stop switch to the STOP
position.
NOTE: When turning the key to OFF
position, the vehicle electrical system
will take a few seconds to shut down.
_______________
Use the low speed range
CONTROLS
65