Fault Code Mode; Navigating In The Lcd Gauge - BRP can-am COMMANDER 2017 Series Operator's Manual

(1)
To erase the MAINTENANCE RE-
QUIRED message, proceed as fol-
lows:
1. Select PARK.
2. Turn ignition switch to ON. Do NOT
start engine.
NOTE: The steps 3 through 9 must be
completed within 5 seconds.
3. Press override switch and HOLD.
4. Press and release brake pedal.
5. Release override switch.
6. Press and release brake pedal.
7. Press override switch and HOLD.
8. Press and release brake pedal.
9. Release override switch.
10. Turn ignition switch to OFF
NOTE: Do not turn ignition switch to
ON before the multifunction gauge
turns off.

Fault Code Mode

Press and hold mode button while
switching high and low beam (three cy-
cles) to access diagnostic fault codes.
Navigating in the LCD
Gauge
Default Display Mode
After vehicle startup, the default dis-
play mode is either:
– Vehicle speed
– Engine revolutions per minute
(RPM)
– Both parameters simultaneously
(combined mode).
To change from one display to the
other, proceed as follows.
1. Turn ignition key to ON to power up
the system up.
2. Wait until the "greeting message"
has been displayed.
3. Press and release selector button
once to display OD (odometer).
MULTIFUNCTION GAUGE (LCD) (DPS MODEL ONLY)
4. Press the selector button again, this
time for 2 seconds.
This will change the Mode to either
Speed, RPM or Combined.
vdd2008-001-083
5. To select another mode, repeat
steps 3 and 4 until the desired mode
is displayed.
Temporary Display Mode
In the temporary display mode, the fol-
lowing functions are available:
– Odometer
– Clock
– Trip meter (resettable)
– Trip Hour meter (resettable)
– Engine hour meter.
Press and release selector button to
change the default display mode to the
temporary mode.
tmo2011-001-702_c
1. Selector button
The gauge will display the selected
mode for 10 seconds then will return
to the normal display mode.
While in a resettable mode, push and
HOLD selector button for 2 seconds to
reset it.
_______________
59