Table of Contents
Advertisement
Lighting, windscreen wipers and washers ›
Beam of light in front of the vehicle has shortened
Headlight defective.
›
Seek the help of a specialist garage.
Driving lights defective
If a message regarding the failed driving lights is dis-
played, the light will work in emergency mode.
›
Drive on, exercising appropriate caution.
›
Seek the help of a specialist garage.
COMING HOME, LEAVING HOME
exterior lighting
Functionality
The COMING HOME function turns on the light after
turning off the ignition and opening the driver's door.
The light switches off automatically after the set
lighting time has elapsed.
The LEAVING HOME function switches on the light
when unlocking the vehicle with the wireless remote
control.
Operating conditions
✓ Visibility has worsened.
✓ The light switch is in the
Settings
This function is set in the following menu in the Info-
tainment system:
Light Assist high-beam assist system
Functionality
The high beam assist system automatically switches
the high beam on and off.
WARNING
Risk of accident!
If necessary, manually switch the high beam on or
▶
off.
Operating conditions
✓ The system is activated.
✓ The light switch is in the
✓ The driving speed is higher than 60 km/h (for
some countries, higher than 40 km/h).
✓ The low beam is switched on.
COMING HOME, LEAVING HOME exterior lighting
Operation
Switching on
Switching off
›
Manually switch the high beam on or off.
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example:
The headlights/lights of oncoming vehicles are
▶
covered by crash barriers, for example.
The headlamps/lights of the oncoming or preced-
▶
ing vehicle are dirty or not functioning.
Settings
Activation/deactivation
position.
The function is activated or deactivated as follows in
the Infotainment system in the menu
Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
After changing a bulb in the low beam light, the main
beam or fog light, have the headlights adjusted by a
specialist garage.
Halogen lamps are pressurised and can burst during
replacement!
Wear gloves and safety goggles.
▶
Contamination of the halogen lamp reduces the life
of the lamp!
position.
Do not touch the glass of the light bulb with your
▶
bare fingers.
›
It lights up in the instru-
ment cluster
the isolation box.
CAUTION
NOTICE
39
Push the lever in the
direction of the arrow.
from
.
Advertisement
Table of Contents
