Checking The Assembly Bracket - Skoda Octavia III 2013 Workshop Manual

– Release screws -arrows- and remove gearbox mount -1-.
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
Screws which have been tightened firmly to a torqueing angle
must be replaced.
Caution
There is a risk of damaging the thread in the gearbox support
bracket by positioning the bolts obliquely.
♦ Before screwing in the screws -arrows- the gearbox sup‐
port bracket and supporting arm of the gearbox mount
must be absolutely parallel to each other. If necessary,
push up gearbox at the rear using a hydraulic trolley jack.
♦ Do not remove support bracket - T30099 - until the bolts
securing the assembly mounting have been tightened to
specified torque.
– Lift gearbox with the support bracket spindle until the gearbox
support bracket is touching the supporting arm of the gearbox
mount.

– Checking the assembly bracket

– Disconnect support bracket - 10 - 222 A- from engine.
Tightening torques
♦ Assembly bracket Octavia III
⇒ "2.1 Assembly bracket - Summary of components (Octavia
III)", page 33
♦ Assembly bracket Yeti
⇒ "2.2 Assembly bracket - Summary of components (Yeti)",
page 35
♦ Engine control unit ⇒ "7 Engine control unit", page 252
2.6 Checking the assembly bracket
The following dimensions must be reached:
• A distance of -a- = 10 mm must be present between engine
support -1- and engine mount -2-.
• The cast edge on the engine support -2- must be parallel -b-
with the engine mount supporting arm -1-.
• The dimension -a- must be the same on the front and rear.
Note
The distance -a- = 10 mm can be checked, for example with suit‐
able round bars.
– If the measured distance is too great or too small, adjust the
assembly bracket ⇒ page 42
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
⇒ page 41 .
.
1.6/81 kW MPI engine - Edition 06.2014
41
2. Assembly bracket