Installation position of rear clamp
– Install clamping sleeve in the position shown.
•
Angle -α- = approximately 20°.
•
Nuts upwards.
•
30 Nm
1.3
Removing and installing catalytic con‐
verter with pre-exhaust pipe
Special tools and workshop equipment required
♦ Transport security - T10403-
♦ Hot bolt paste ⇒ Electronic Catalogue of Original Parts"ETKA"
Note
The catalytic converter is removed with the pre-exhaust pipe.
Removing
Note
All cable straps should be fastened again in the same place when
installing.
– Take electrical plug connections -1- and -2- out of the holder,
disconnect and expose electric cables.
Note
Before undoing the coupling point between catalytic converter
♦
and turbocharger, make the position of the clamp
⇒ page 275
!
Mark the part opposite the part to be replaced.
♦
Re-establish the position of the clamp when assembling.
♦
Position of the clamp
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Removing and installing exhaust system
275