Removing And Installing The Parking Aid Control Unit J446 - Skoda Octavia II 2004 Workshop Manual

1 - Rear parking aid sender
❑ below the protective
strip of the rear shock
absorber
❑ Removing and installing
⇒ page 153
2 - Control unit for the parking
aid - J446-
❑ behind the left luggage
compartment trim panel
❑ Removing and installing
⇒ page 151
3 - Rear parking aid warning
buzzer - H15-
❑ in the trim panel of pillar
B
❑ Removing and installing
⇒ page 152
4 - Front parking aid sender
❑ below the protective
strip of the front shock
absorber
❑ Removing and installing
⇒ page 153
5 - The warning buzzer for the
front parking aid - H22-
❑ behind the right dash
panel insert
❑ Removing and installing
⇒ page 152
❑ installed in vehicles as
of MY 09
9.2 Removing and installing the parking aid
control unit - J446-
Removing
– Switch off the ignition and all electrical consumers!
– Remove right side trim panel in luggage compartment ⇒ Body
Work; Rep. gr. 70 .
– Release and disconnect the plug connections.
– Release nuts -arrows- (1.5 Nm) and take out parking aid con‐
trol unit.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– When replacing, code the new parking aid control unit - J446-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
⇒ Vehicle diagnostic tester.
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
151
9. Parking aid