Fuel Delivery Unit/Fuel Gauge Sender For Vehicles With Four- Wheel Drive - Summary Of Components - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
1.7 Fuel delivery unit/fuel gauge sender for vehicles with four-wheel drive -
Summary of components
1 - Fuel gauge sender - G-
❑ carry out an electrical
check on the fuel pump
control unit - J538-
⇒ Vehicle diagnostic
tester
❑ Removing and installing
⇒ page 240
2 - Fuel delivery unit
❑ with fuel system pres‐
surisation pump -G6-
❑ with integrated fuel filter,
the fuel filter cannot be
replaced individually
❑ Checking fuel pump
electrics ⇒ Vehicle diag‐
nostic tester
❑ Removing and installing
⇒ page 236
❑ Fill the vehicle with at
least 5 litres of fuel after
installing
3 - Sealing ring
❑ Replace after disas‐
sembly
❑ install when dry
4 - Fuel line
❑ to auxiliary heating
❑ do not kink
❑ Removing and installing
⇒ page 236
5 - Fuel feed line
❑ to the engine
❑ do not kink
❑ disconnect and connect
6 - Connector
❑ For fuel pump control unit - J538-
❑ Ensure safe locking by pulling
7 - Fuel pump control unit - J538-
❑ check ⇒ Vehicle diagnostic tester
❑ Removing and installing
8 - Connector
❑ for fuel system pressurisation pump - G6- and fuel gauge sender - G-
❑ Ensure safe locking by pulling
9 - Connector
❑ for sender for fuel gauge display - G- and sender for fuel gauge display 2 - G169-
❑ Ensure safe locking by pulling
10 - Lock ring
❑ loosen and/or tighten using wrench - T30101 (3087)-
232
Rep. gr.20 - Fuel supply system
⇒ page 250
⇒ page 248