Removing And Installing Parking Aid Senders - Skoda Octavia II 2004 Workshop Manual

9.5 Removing and installing parking aid
senders
Note
The visible area of a new sender must be painted in the colour
♦
of the bumper before installing.
The parking aid senders must only be painted with a max. 100
♦
µm thick layer of paint. Before painting the sender, the rear
parts of the sender (terminal connection) must be affixed.
Only the upper part (visible part) of the sender membrane is
♦
painted.
To make it easier to remove the catches -arrow A- you can use
♦
a larger set of Seeger pliers with angled jaws.
Removing front sender
– Switch off the ignition and all electrical consumers!
– Remove front bumper ⇒ Body Work; Rep. gr. 63 .
– Pull off retaining catches on sender -arrows A-.
– Press out the sender -1- on the outer side of the shock ab‐
sorber inwards.
– Disconnect plug connection -2-.
Remove rear sender
Note
Before the plug connections are disconnected from the senders
and the wiring loom is loosened, the left and right wiring loom side
has to be marked so that no undesirable change can occur when
installing. On vehicles where the distance and location of the ob‐
stacle (left/right) is shown in the radio display (e.g. radio "Stream"
or "Audience") the obstacle would be indicated on the wrong side.
– Switch off the ignition and all electrical consumers!
– Remove rear bumper ⇒ Body Work; Rep. gr. 63 .
– Pull off retaining catches on sender -arrows A-.
– Press out the sender -1- on the outer side of the shock ab‐
sorber inwards.
– Disconnect plug connection -2-.
Installing
The installation occurs in reverse order.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
153
9. Parking aid