Intake Manifold And Fuel Distributor; Intake Manifold - Summary Of Components - Skoda Octavia III 2013 Workshop Manual

3

Intake manifold and fuel distributor

⇒ "3.1 Intake manifold - Summary of components", page 289
⇒ "3.2 Removing and installing intake manifold", page 290
⇒ "3.3 Removing and installing the throttle valve control unit J338
", page 294
⇒ "3.4 Clean throttle valve control unit J338 ", page 296
3.1

Intake manifold - Summary of components

1 - Screw
❑ 20 Nm
2 - Intake manifold support
3 - Nut
❑ 10 Nm
4 - Rubber bearing
❑ 5 Nm
5 - Screw
❑ 7 Nm
6 - Throttle valve control unit -
J338-
❑ with throttle valve drive
for electrical gas actua‐
tion - G186- , Angle
gearbox 1 for throttle
valve drive - G187- and
angle gearbox 2 for
throttle valve drive -
G188-
❑ clean the original throt‐
tle valve control unit -
J338- before re-instal‐
ling it ⇒ page 296
❑ after removing and in‐
stalling or replacing the
throttle valve control unit
- J338- it will need to be
re-adjusted to the en‐
gine control unit - J623-
⇒ Vehicle diagnostic
tester
7 - Sealing ring
❑ Replace after disas‐
sembly
8 - Intake manifold
❑ Removing and installing
9 - Potentiometer for intake manifold flap - G336-
❑ After each time you remove and install or replace, the potentiometer for intake manifold - G336- will need
to be re-adjusted to the engine control unit - J623- ⇒ Vehicle diagnostic tester
10 - Ball pin
❑ for engine cover
❑ 5 Nm
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
⇒ page 290
Octavia III 2013 ➤ , Octavia III 2014 ➤
3. Intake manifold and fuel distributor
289